Samsung RL39TJCSW Manuale Utente Pagina 8

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 16
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 7
8_ setting up
6. Unscrew the leg front and 2 screws at the
Bottom hinge. (Figure
7
)
Before removing the Bottom hinge,
remove the leg.
7. Switch the position of the Bottom hinge shaft.
Remove the screw on the Auto guide(A) and
remove the Bottom hinge shaft with 11 mm
wrench. Attach the Bottom hinge shaft(B) on the
left and put the reversed Auto Guide back.
(Figure
8
)
8. Attach the Bottom hinge on the bottom left side
of the refrigerator where 2 screws was previously
removed in step 8. Screw remaining bolt on the
bottom right side of the refrigerator for the future
usage. (Figure
9
)
9. Switch the position of the Middle hinge cap(A),
from left to the right side. (Figure
10
)
10. Remove the screw on the bottom right side of
the Freezer door.
Switch the position of the Door stopper(A) and
the Hinge grommet(B) and Bracket Stopper
door from the right to the left. (Figure
11
)
11. Switch the Hinge grommet(A) and the Grommet
cap(B) on the top of the Freezer door.
(Figure
12
)
12. Carefully put the Freezer door back on.
(Figure
13
)
13. Assemble the Middle hinge with 2 bolts on the
left side. (Figure
14
)
14. Remove the screw on the bottom right side of
the Fridge door.
Switch the Door stopper(A) and the Hinge
grommet(B) and Bracket Stopper door from the
left. (Figure
15
)
15. Use 11mm wrench to separate the Top hinge
shaft. Flip the Top hinge and reattach the Top
hinge shaft. (Figure
16
)
16. Assemble a Top hinge to left side of the Fridge
Door. (Figure
17
)
17. Carefully put the Fridge door back on.
Then tighten 3 bolts to assemble the Top hinge.
(Figure
18
)
You must reverse the Type B door handle
before putting the Fridge door back.
For Door handle Type A, make sure to
switch the door handle after reversing the
door.
18. Assembly the Fridge Door to the top of the Ref.
(Figure
19
)
19. Switch the side of the Door cap on the top of
the Fridge door. (Figure
20
)
Make sure that red tape on the wire is
positioned on the end of the Top left hinge
cover.
20. Switch the side of the Display cover Cap.
(Figure
21
)
After reversing the doors, make sure
the Fridge and Freezer door gaskets are
properly arranged. If not, there might
be a noise or dew formed which affects
perfomance of the refrigerator.
21. Take off the handle cover and remove the
screws, make sure to attach the caps and the
handle at the right side of the door.(Make sure
to cover the right side with detached caps.)
caps and the handle from the right to left side of
the door. (Figure
22
)
LEVELLING THE REFRIGERATOR
If the front of the appliance is slightly higher than
the rear, the door can be opened and closed
more easily.
Turn the adjusting legs clockwise to raise and
counter-clockwise to lower the height. (Figure
23
)
Case 1) The appliance tilts down to the left.
Turn the left adjusting leg in the direction of the
arrow until the appliance is level.
Case 2) The appliance tilts down to the right.
Turn the right adjusting leg in the direction of the
arrow until the appliance is level.
CAUTION
DA99-03236N(EN)-09.indd Sec4:8DA99-03236N(EN)-09.indd Sec4:8 2012.6.5 10:38:20 AM2012.6.5 10:38:20 AM
Vedere la pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commenti su questo manuale

Nessun commento