
10
Installing the Hob
Important: Be sure the new appliance is installed and grounded only by qualied
personnel.
Please observe this instruction. The warranty will not cover any damage that may
occur as a result of improper installation.
Technical data is provided at the end of this manual.
Safety instructions for the installer
• A device must be provided in the electrical installation that allows the appliance to be discon-
nected from the mains at all poles with a contact opening width of at least 3 mm. Suitable
isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed
from the holder), earth leakage trips and contactors.
• With respect to re protection, this appliance corresponds to EN 60 335 - 2 - 6. This type of
appliance may be installed with a high cupboard or wall on one side.
• Drawers may not be tted underneath the hob.
• The installation must guarantee shock protection.
• The kitchen unit in which the appliance is tted must satisfy the stability requirements of DIN
68930.
• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.
• On tiled work surfaces, the joints in the area where the hob sits must be completely lled with
grout.
• On natural, articial stone, or ceramic tops, the snap action springs must be bonded in place
with a suitable articial resin or mixed adhesive.
• Ensure that the seal is correctly seated against the work surface without any gaps. Additional
silicon sealant must not be applied; this would make removal more difcult when servicing.
• The hob must be pressed out from below when removed.
C61R2CAST_BOL_00121B-04_BG+HR+MK+RO+SR+SL+EN.indb 10 2016-11-28 12:09:49
Commenti su questo manuale