
English 17
02 Connections
Installing the Speakers on the Tallboy Stand
* HT-C553 only - Front Speakers
* HT-C555 only - Front/Rear Speakers
Turn the Stand Base upside-down and connect it to
the Stand.
Insert small screws (4*20, For connecting Stand & Stand
Base) clockwise into the four holes marked using a
screwdriver as shown in the illustration.
CAUTION : When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm)
Connect the upper Speaker to the assembled Stand.
Insert another large
screw (5*15, For connecting Speaker
& Stand)
clockwise into the hole on the rear of the
speaker using a
screwdriver.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
1.
2.
!
3.
4.
5.
In case of HT-C550
iPod
DIGITAL
AUDIO IN
OPTICAL
Front Speaker (R)
Subwoofer
Rear Speaker (R) Rear Speaker (L)
Front Speaker (L)
Centre Speaker
* Refer to page 16 for the speakers of HT-C553/C555.
Connecting The Speakers
Press down the terminal tab on the back of the speaker.
Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.
Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
1.
2.
3.
Black
Red
1 2
3 4
Stand
Stand
Base
Stand
Speaker
5
HT-C550-ELS_ENG-0607.indd 17HT-C550-ELS_ENG-0607.indd 17 2010-06-07 10:55:002010-06-07 10:55:00
Commenti su questo manuale