Samsung WA45M3100AW/A4 Manuale Utente Scaricare il pdf (Pagina 27)

English 27

Installation

STEP 5 Powering your washer

Plug the power cord into a 3-prong,

well grounded 120 volt 60 Hz approved

electrical outlet protected by a 15-amp fuse

or comparable circuit breaker.

Your washer is grounded through the third

prong of the power cord when plugged into

a three-prong grounded electrical outlet.

Test run

Make sure that you install your washer

correctly by running the RINSE + SPIN after

the installation is complete.

STEP 6 Running a test cycle

Run a test cycle as follows to check if your washer is properly installed.

1. Load about 6 pounds of laundry into the tub.

2. Press POWER to turn on your washer.

3. Select RINSE + SPIN by turning the Cycle Selector.

4. Press START/PAUSE to start the test cycle.

5. The washer should not rock or vibrate excessively when water is supplied or when

washing or spinning, and should drain well during the spin cycle.

NOTE

If water leaks while water is being supplied or drained, check the water connections. Refer to

the “STEP 2 Connecting the water supply hose” section on page 21 for instructions.

NOTE

If the washer rocks and vibrates excessively, level your washer again. Refer to the “STEP

4 Leveling your washer” section on page 25 for instructions.

WA3100M_DC68-03850A-02_EN.indd 27 2018-04-11  10:58:22

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 203 204

Nessun commento

Samsung WA45M3100AW/A4 Manuale Utente Pagina 27